Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Carburetor page 56
Figure 21—Assembling Carburetor Body to Carburetor Throttle Bodyr. Main Adjustment Ratchet. Replace the main adjustmentratchet if it is broken (fig. 18).223. ASSEMBLY.This procedure consists of installing all parts, such as levers, springs,valves, etc., on the carburetor.a. Assemble Carburetor Body. Place the choke return spring onthe choke shaft and lever. Install new felt seals on the lever end ofthe choke shaft. Install the choke shaft and spring in the carburetorbody. Hook the choke return spring on the peg on the body and onthe lever so that the choke shaft lever will rest on the peg. Install thechoke plate in the choke shaft. While holding the choke plate in theclosed position, install and tighten the two choke plate screws andwashers. Install the maximum fuel limiting jet in the carburetor body(fig. 19) with a small screw driver or jet wrench. Install the mainnozzle and new gasket.b. Assemble Carburetor Throttle Body. Install the idler jetand economizer jet (fig. 18) in the throttle body with a small screwdriver or jet wrench. Install the float needle and a new gasket with ajet wrench. Install a new felt seal on the lever end of the throttle shaft.Install the throttle shaft and lever in the throttle body. Place thethrottle plate on the throttle shaft, and install the two screws and lockwashers. Hold the throttle lever in the closed position, and tighten3675-48-C§223.b.56CARBURETOR BODYRM-463THROTTLE BODYFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
