Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Fits and tolerances page 50
142. FITS AND TOLERANCES.FIT LOCATIONNAMECylinder bore out-of-roundCylinder bore taper ormaximum wearClearance betweencamshaft andbearingClearance betweenpush rod andpush rod boreCYLINDER BLOCKORIGINAL FITTOLERANCES0.001 in. to0.002 in.0.0005 in. to0.0015 in.FIT WEARLIMIT TYPE OFFIT0.003 in.0.006 in.0.004 in. Running0.003 in.CONNECTING ROD AND PISTON ASSEMBLYFIT LOCATIONNAMEConnecting rod sideclearancePiston pin clearance inconnecting rodPiston pin clearancein pistonORIGINAL FITTOLERANCES0.004 in. to0.008 in.0.0002 in. to0.0005 in.0.000 in. to0.0005 in.Piston and cylinderTop piston ring togroove side clearanceBalance of piston ring togroove side clearancePiston ring end gap6 pounds to 10pounds pull witha thicknessgauge 0.003 in.and 1/2 in. wide0.0015 in. to0.0030 in.0.0010 in. to0.0025 in.0.012 in. to0.017 in.FIT WEAR TYPE OFLIMITFIT0.011 in.0.0015 in. Slip0.0015 in. (LightPush)6 poundsto 10pounds pullwith athicknessgauge 0.005in. and 1-2in. wide0.004 in.0.004 in.0.035 in.3695-4750ยง 142.Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
