Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Carburetor page 55
Figure 20—Measuring Float Level (4-Cylinder Engine Carburetor)h. Main Nozzle. Replace the main nozzle (fig. 19) if it is bent, orif the threads are stripped.i. Main Adjustment Needle. Replace the main adjustment needle(fig. 18) if the threads are stripped or if the valve is ridged.j. Main Adjustment Needle Spring. Replace the main adjust-ment needle spring (fig. 18) if it is weak or broken.k. Choke Shaft Spring. Replace the choke shaft spring (fig. 19)if it is broken or weak.1. Float Needle and Valve Seat. The float needle and valve seatare matched in sets, therefore, when one is at fault, both must bereplaced. Replace both the needle and the seat (fig. 18) if there is anyindication of wear on either part.m. Economizer Jet. Replace the economizer jet (fig. 18) if thethreads are stripped or if the jet is damaged in any way.n. Maximum Fuel Limiting Jet. Replace the maximum fuellimiting jet (fig. 18) if the threads are stripped, or if the jet is damagedin any way.o. Idler Jet. Replace the idler jet (fig. 18) if the threads arestripped or if the jet is damaged in any way.p. Idle Adjusting Needle. Replace the idle adjusting needle (fig.18) if the threads are stripped or if the valve surface is ridged.q. Idle Adjusting Needle Spring. Replace the idle adjustingneedle spring (fig. 18) if it is broken.§ 222. q.3675-48-C55FLOATCARBURETORTHROTTLE BODYFloat Position Gauge— 9550-D"Go" Diameter—0.260"No Go" Diameter—0.297RM-444Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
