Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Definition of fits page 48
FITS AND TOLERANCESSectionDefinition of Fits141Fits and Tolerances142Torque Wrench Readings143141. DEFINITION OF FITS.The Table of Fits and Tolerances (Sec. 142) gives the originalclearance established between various parts at the time of manu-facture, as well as wear and limit clearances that indicate to whatpoint the clearance may increase before the parts must be replaced.These clearances are based on the parts involved, all being at 70° F.The following definitions of the various types of fits are given toassist in arriving at the correct amount of clearance between partsnot included in section 142, as well as to give a better appreciationof why the various tolerances must be adhered to. Generally speak-ing, all bores are made to a standard size (so that standard reamers,plug gauges, etc., may be used) with a plus tolerance. The maximumsize of the male parts is usually a standard size less the minimumclearance required for the type of fit desired. The minimum size formale parts is the maximum size minus the tolerance.a. Wring Fit. A wring fit is the type of fit required between a boreand a plug gauge, when using the plug gauge, to determine the insidediameter of the bore. With a wring fit, it is necessary to turn orwring the plug gauge or part to force it through the bore. This typeof fit does not provide space for a film of oil.b. Slip Fit. A slip fit exists when the male part is slightly smallerthan the female part and involves less clearance than a running fit(par. c below). An example of the minimum allowable clearance fora slip fit would be a piston pin that, from its own weight, would passslowly through the connecting rod bushing (bushing and pin both ina vertical position). In most cases (except where only a limited move-§ 141. b.3695-4748Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
