Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Carburetor page 57
the two throttle plate screws. Install the idle fuel adjusting screw andspring. Turn the screw in until it seats lightly, then back it out3/4ofa turn. Place the venturi (fig. 18) in the gasket. Place the gasket onthe throttle body so the large end of the venturi seats in the throttlebody. Place the float needle valve in the float needle valve seat. Installthe float in the throttle body. Secure the main adjustment ratchet tothe throttle body with two screws and washers. Set the float to thecorrect level (fig. 20).c. Assemble Carburetor Throttle Body to Carburetor Body.Place the carburetor throttle body on the carburetor body, as shownin fig. 21, being careful not to bend the float. Secure the carburetorthrottle body to the carburetor body with four screws and lockwashers. Install the main adjustment needle assembly, using a newgasket (fig. 18). Turn the adjustment needle in until it is seated lightly,then turn it out 11/4to 11/2turns.223. C.3675-48-C57Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
