Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Crankshaft and flywheel page 14
INSPECTION AND REPAIRSectionCrankshaft and Flywheel121Cylinder Block122Piston and Connecting Rods123Camshaft and Valve Mechanism124Cylinder Head and Front Cover125Oil Pump126Water Pump127Governor128Oil Pan, Intake and Exhaust Manifolds129121. CRANKSHAFT AND FLYWHEEL.The disassembled crankshaft and flywheel assemblies are shownin figs. 10 and 11.a. Crankshaft. Clean out the drilled oil passages in the crankshaftjournals with a piece of wire. Clean the crankshaft thoroughly withcleaning solvent. Replace the crankshaft flange dowels if they aredamaged. Replace a crankshaft gear that has chipped, broken, orworn teeth (subpar. (2) below). If the main journals or the crankpinjournals are grooved or scored, the crankshaft must be remachinedor replaced (subpar. (l) below). Light scores or scratches can behoned, then polished with No. 320 grit polishing paper. Measure14Fig. 8—Removing Crankshaft GearCrankshaft Gear Remover—6306-CCRANKSHAFT GEARCRANKSHAFTRM-507§ 1.21. a.3695-47Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
