Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Governor page 34
Fig. 35—Pressing Bearing and Shaft from Pulley Hubd. Assembly. Press a new bushing in the body if the old one wasremoved. Dip a new seal and seal washer (fig. 31) in hydraulic brakefluid. Install the spring and seal assembly, seal washer, and snapring in the impeller. Press the bearing and shaft assembly into thebody (fig. 31). Press the impeller onto the shaft until it is flush withthe end of the shaft. Install the water pump body snap ring in thebody. Press the pulley onto the shaft until the pulley is flush withthe shaft128. GOVERNOR.Remove the screw (fig. 36) that secures the driver unit to thebody. Lift the driver unit from the body. Remove the hairpin clip,then remove the flat washer, shims, fork base, thrust bearing, upperrace and balls (fig. 37) from the shaft. Remove the oil tube elbowconnection from the body. Drive the grooved pin out of the forkand lever as shown in fig. 38. Pull the levers out of the body. Removethe dust seal and needle bearing from the body.a. Inspection. Inspection of the governor should follow thenine procedures as given below(1) DRIVE GEAR. Replace the drive gear (fig. 39) (par. b below)if it is chipped or worn.(2) BALL BEARING BASE. Replace the ball bearing base (fig.37) (par. b below) if it is cracked or damaged in any way.§ 128. a. (2)3695-4734PullerWATER PUMP HOUSINGSHAFT AND BEARING ASSEMBLY RM-594Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
