Chapters
Chapter 5 - Rear Axle
Disassembly page 79
Chapter5REAR AXLESectionDisassembly151Inspection and Repair152Assembly153151. DISASSEMBLY.To disassemble the axle, remove the axle shaft nut lock ring, andremove the axle shaft nut, flat washer, and seal (fig. 34). Removethe hub from the axle shaft (fig. 33). Remove the cap screws andnuts that secure the brake support plate to the axle shaft housing,and remove the brake support plate assembly. Remove the oil sealretainer from the bearing retainer (fig. 34). Repeat this procedureto remove the other brake support plate. Remove the brake dustshield assembly and the oil seal. Be sure to keep the shim packintact to facilitate reassembly.Lift the axle shafts from the axle housing. Remove the nuts thatsecure the left-hand axle housing to the center housing, and removethe axle housing. Lift the differential from the center housing (fig.35). Remove the right-hand axle housing from the center housing.Fig. 32—Rear Axle Assembly3730-47J79§ 151.ROCKERHOUSINGBACKING PLATEBRAKE CAM SHAFTCENTER HOUSINGDRIVE PINIONBRAKE PEDALHOUSINGBACKING PLATERM-596Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
