Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Installation of accessories page 46
Install the crankshaft packing in the recess provided in thecylinder front cover. Insert a new gasket and cylinder front coveron the engine. Insert a thickness gauge between the camshaft gearand cylinder block while forcing the camshaft ahead with a hammerhandle (fig. 54). If a clearance of more than 0.004 inch exists, replacethe cylinder front cover.i. Install Oil Pan.NOTE: Soak the crankshaft packing in oil for two hours beforeinstallation.Install the packing in the recess at each end of the oil pan. Coatthe bottom machined surface of the crankcase with grease to holdthe oil pan gasket in place. Install the oil pan gasket on the cylinderblock. Position the oil pan on the cylinder block, and install the capscrews.j. Install Crankshaft Pulley. Place the crankshaft pulley on thecrankshaft. Turn the pulley by hand until the slot in the pulley islined up with the woodruff key in the crankshaft. Drive the pulleyon the crankshaft with a fiber block. Install the crankshaft ratchet.k. Install Cylinder Head. Place a new head gasket on the cyl-inder block. Make sure there is no foreign matter either in the cylin-ders or on the surface of the cylinder head or block. Place the cyl-inder head on the cylinder block. Install and tighten the cylinderhead nuts from 50 to 60 pounds-feet. When tightening nuts, startfrom a centrally located nut, and tighten alternately each way.1. Install Water Pump. Position the water pump and gasket onthe cylinder block, and install the nuts and cap screw.m. Install Intake and Exhaust Manifolds. Place the intakeand exhaust manifold gaskets on the cylinder block studs. Secure themanifold to the cylinder block with the four nuts.132. INSTALLATION OF ACCESSORIES.The following instructions are based on the assumption that thevarious accessories are in good working order. Overhaul or repairaccessories before installation if required.a. Install Starting Motor. Position the starting motor (fig. 1)on the cylinder block, and tighten the two starting motor cap screws.ยง 132. a.3695-4746Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
