Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Accessory removal page 9
Fig. 2—Right3/4Front View of EngineValve stem clearance to push rods:Intake0.010 to 0.012 in.Exhaust0.014 to 0.016 in.Valve liftersNon-adjustable112. ACCESSORY REMOVAL.In the disassembly procedures throughout this manual, dis-assembly is carried out only to the extent necessary for completeinspection of the parts subject to wear. The replacement or repairof the individual parts thus inspected is referred to as repair.a. Remove Generator. Remove the nuts that secure thegenerator adjustment bracket to the timing gear side cover andgenerator. Disconnect the generator wiring. Remove the bolt andwasher that secure the generator to the cylinder front cover, andremove the generator (fig. 2).b. Remove Oil Filter. Disconnect the oil inlet line at the cylinderblock. Disconnect the oil return line from the governor. Remove thetwo cap screws that secure the oil filter bracket to the cylinder head.Remove the oil filter and lines (fig. 1).c. Remove Distributor and Spark Plug Wires. Remove thetwo nuts that secure the spark plug wire conduit to the cylinderhead. Remove the two cap screws and lock washers that secure the3695-47§ 112. C.9CYLINDER HEADSPARK PLUGWIRE CONDUITINTAKE ANDEXHAUST MANIFOLDGENERATORCYLINDERBLOCKCARBURETOR OIL PAN GOVERNOR SUPPORTFAN BELTRM-502FANCOILDISTRIBUTORFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
