Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Torque wrench readings page 51
VALVESStem to guide clearance(exhaust)Stem to guide clearance(intake)Valve seat angleSpring tension at 2.125inchesClearance between valvestem and push rod(exhaust)Clearance between valvestem and push rod(intake)Clearance betweendriven gear and shaft40.0025 in. to0.0045 in.0.0015 in. to0.0035 in.45 degrees31 to 34 lbs.0.14 to 0.16 in.0.006 in.0.005 in.30 lbs.0.015 in.0.010 to 0.012 in. 0.013 in.OIL PUMP0.002 in. to0.0035 in.RunningRunning0.005 in. RunningCrankshaft end playMain bearing clearanceCrankpin to connectingrod clearance0.002 in. to0.006 in.0.000 in. to0.003 in.0.0013 in. toO.0035 in.0.008 in.0.005 in. RunningRunning0.005 in. andFloating143. TORQUE WRENCH READINGS.Main bearing nuts75 to 80 lbs.-ft.Self-locking main bearing bolts.100 lbs.-ft.Connecting rod castellated nuts35 to 40 lbs.-ft.Connecting rod self-locking nuts40 to 45 lbs.-ft.Cylinder head nuts50 to 55 lbs.-ft.Flywheel cap screws65 to 75 lbs.-ft.Flywheel self-locking cap screws75 to 85 lbs.-ft.Spark plugs24 to 30 lbs.-ft.3695-47ยง143.51FIT LOCATIONNAMECRANKSHAFTORIGINAL FITFIT WEAR TYPE OFTOLERANCESLIMITFITFIT LOCATIONORIGINAL FITFIT WEAR TYPE OFNAMETOLERANCESLIMITFITFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
