Chapters
Chapter 4 - Belt Pulley
Disassembly page 75
Chapter4BELT PULLEYSectionDisassembly171Inspection and Repair172Assembly173171. DISASSEMBLY.Remove the filler plug (fig. 50) and allow the oil to drain. Removethe four cap screws that secure the cover to the housing. Removethe cover and gasket. Remove the cotter pin, castellated nut, washer,driven gear, and bearing from the pulley shaft. Tap on the side of thepulley to remove the shaft from the housing. Remove the four capscrews that hold the pulley to the shaft. Remove the pulley. Lift thedrive gear and bearing assembly from the housing. Remove both oilseals from the housing.Fig. 50—Belt Pulley3730-47J§171.75HOUSINGFILLER PLUGRM-612COVERPULLEYFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
