Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Pistons and connecting rods page 21
Fig. 16—Measuring Width of Valve Seat123. PISTONS AND CONNECTING RODS.To disassemble the piston and connecting rod, remove the pistonrings with a piston ring expander. Remove the two piston pinretainers (fig. 17), and push the piston pin out of the piston. Scrapethe carbon from the piston ring grooves and also from the top of thepistons. Clean all carbon and sludge from the oil holes in the oilring groove. Make sure all of the oil holes in the connecting rod areopen. Clean all parts thoroughly.Fig. 17—Connecting Rod and Piston Assembly, Disassembled3695-47§ 123.21ScaleCYLINDER BLOCKVALVE SEATRM-512PISTON PIN RETAINER—6140PISTON—6110PISTON RINGSRM-513PISTON PIN—6135PISTON PIN RETAINER—6140CONNECTING ROD—6200INSERT BEARINGS—6211LOCK NUTSFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
