Chapters
Chapter 3 - Power Take-Off
Disassembly page 71
Chapter3POWER TAKE-OFFSectionDisassembly161Inspection and Repair162Assembly163161. DISASSEMBLY.The disassembled power take-off assembly is shown in fig. 48.a. Power Take-off Adapter. To disassemble the power take-offadapter, remove the three cap screws which secure the shield andbearing cap (fig. 44) to the housing. Remove the shield and bearingcap from the housing. Drive the bearing and shaft assembly out ofthe housing. Grind the head off the rivet that secures the sleeve tothe shaft. Remove the rivet from the shaft and sleeve. Pull the sleeveoff the shaft. Remove the oil seal from the housing.71Fig. 44—Power Take-off Adapter3730-47J§ 161. a.SHIELD11/16"SPLINED SHAFTHOUSING13/8" SPLINED SHAFTRM-647Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
