Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 7 - Steering Gear

Adjustments page 101

Ford 8N, 9N, 2N Service Manual, page 101Chapter7STEERING GEARSectionAdjustments121Disassembly122Inspection and Repair123Assembly124The steering system includes the steering gear, steering wheel,and steering drag links between the pitman arms and the front axlespindle arms. The steering gear is of the recirculating ball bearingworm and nut type. Anti-friction steering is achieved by steel ballswhich serve as rolling contacts between the worm and nut.Rotation of the steering tube shaft moves the ball nut along theworm. The left steering sector engages the rack on the ball nut, andis thereby rotated through an arc by the movement of the ball nut(fig. 2). The right sector engages the left sector and rotates the samenumber of degrees in the opposite direction. The pitman armstransfer the motion of the sector to the spindle arms through thedrag links.121. ADJUSTMENTS.When the wheels are in the straight ahead position, all backlashshould be removed, but if the wheels are turned to the extreme rightor left, a slight backlash will be present due to the gear tooth design.This characteristic permits a backlash adjustment for wear betweenthe worm nut teeth and the sector gears in the much used centerposition without causing binding or tightness in less used portionsof the sector gears and worm nut.Steering gear adjustments may be checked before removing theunit from the tractor or disassembling the unit. Adjusting the steer-ing gear on the tractor in many cases will eliminate excessive back-lash caused by improper adjustment between the sectors and theball nut.To determine the cause of excessive backlash, first check theadjustment of the steering tube bearings. Disconnect the drag linksfrom the pitman arms. Turn the steering wheel to the right or leftto the end of its travel, then back about1/2turn. Measure the forcerequired to rotate it by use of a spring scale attached to the rim(fig. 7). If a force from1/2to11/2pounds will maintain the wheel in3730-47Jยง 121.101

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?