Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Water pump page 32
Fig. 32—Pressing Oil Pump Driven Gear Onto Oil PumpDrive Gear and Shaft(1) DRIVEN GEAR SHAFT REPLACEMENT. Drive thedriven gear shaft from the oil pump body (fig. 31). To install thedriven gear shaft, press it into the oil pump body until the end ofthe shaft is flush with the outside of the oil pump body.(2) DRIVE GEAR BUSHING REPLACEMENT. Drive thebushing from the oil pump body with a driver. To install the bushing,press it into the oil pump body until the inner edge of the bushingis flush with the oil pump body. Ream the bushing from 0.5625 to0.5630 inch diameter.b. Assembly. Place the drive gear in the oil pump body. Pressthe driven gear on the drive gear shaft, making sure the flat in thegear is in line with the flat side of the shaft. Install the driven gearin the oil pump body.127. WATER PUMP.The disassembled water pump is shown in fig. 34.a. Disassembly. Place the water pump in a vise. Drive the shaftout of the pulley with a driver as shown in fig. 33. Remove the snapring (fig. 34) from the water pump body. Press the shaft and bearingassembly out of the water pump body (fig. 34).Remove the water pump seal snap ring, washer, seal and springfrom the impeller (fig. 34).§ 127. a.3695-4732Arbor PressOIL PUMP DRIVEN GEAROIL PUMP BODYOIL PUMP DRIVE GEARRM-509Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
