Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Oil pump page 30
Fig. 29—Checking Valve Guide Bushing for Wear(2) ASSEMBLING VALVE ASSEMBLY. Place the valve springretainer and spring on the valve, and slide both halves of the valveguide bushing in place.125. CYLINDER HEAD AND FRONT COVER.Scrape all of the carbon from the cylinder head. Replace a crackedcylinder head or a head where the gasket surface is warped1/32inchor more over the full length of the head. Replace the head if eitherthe threads in the spark plug holes or the water temperature gaugehole is stripped. Repair any threads that are not stripped but areotherwise damaged. If the threads are damaged in either the sparkplug holes or the water temperature gauge hole, clean up the threadswith the correct size tap.Replace the cylinder front cover and timing gear side cover ifcracked or damaged in any way.Check the gasket surface of the covers for nicks or damage, andmake repairs as required.126. OIL PUMP.Clean all parts thoroughly, and blow out all oil passages withcompressed air. Lift the driven gear from the pump (fig. 31). Pressthe drive gear from the driven gear and body (fig. 30).a. Inspection and Repair. Replace an oil pump body if crackedor damaged. If the inside diameter of the drive gear bushing exceeds0.566 inch, or the outside diameter of the driven gear shaft is lessthan 0.560 inch, replace the bushing or shaft (subpars. (1) and (2)below). Replace the fibre drive gear if it is worn, or if it has broken§ 126. a.3695-4730RMX-416Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
