Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Installation of accessories page 47
b. Install Carburetor. Place the carburetor in place on theintake manifold (fig. 2). Install and tighten the two carburetor nutsand lock washers.c. Install Distributor and Spark Plug Wires. Place the gasketin position on the distributor. Place the distributor in position onthe cylinder front cover, making sure that the tang on the dis-tributor shaft is entered in the slot in the camshaft. Secure the dis-tributor to the cylinder front cover with two cap screws and lockwashers. Secure the spark plug wire conduit to the cylinder head withthe two cap screws.d. Install Oil Filter. Secure the oil filter to the cylinder head(fig. 1) with the two cap screws. Connect the oil filter return line tothe governor and oil filter. Connect the oil filter inlet line to the con-nection located at the right-hand side of the cylinder block and tothe oil filter.e. Install Generator. Hold the generator in place on the cylinderfront cover (fig. 2). Install the cap screw and washer, but do nottighten until the fan belt is adjusted after the engine is installed.3695-4747ยง 132. e.Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
