Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Definition of fits page 49
ment of the parts is involved) slip fits are specified when, due toanticipated expansion (par. f below) of the female part, enough addi-tional clearance will result to change this type of fit to a runningfit (par. c below) and provide adequate clearance for a film of oil.c. Running Fit. A running fit is a fit providing enough clearancefor a continuous film of oil between the two parts. A running fitusually requires 0.001 inch for oil film plus a minimum of 0.001 inchfor each 1 inch of diameter (par. f below).d. Press Fit. A press fit is one that requires force to enter themale part into the bore. Accepted practice for press fits is to havethe male part larger by 0.001 inch for each inch of diameter than thebore into which it is to be pressed.e. Shrink Fit. Generally speaking, a shrink fit is tighter than apress fit. The amount of the shrink ranging from 0.001 inch to 0.002inch for each 1 inch of diameter, and in some cases even more. Theparts having a press fit may be assembled either by force or by theshrink method. There are two methods of shrinking two parts to-gether, either one of which may be used (both may be used in someinstances). One method involves expansion of the female member byheating. The other method involves contracting the male memberby chilling with dry ice or liquid air.f. Effect of Expansion on Fits. Allowances are made in estab-lishing fits on parts that are exposed to higher temperatures in orderto provide for the anticipated expansion of the part during operationand still provide adequate clearance for the type of fit required.Allowances must also be made for unequal expansion of dissimilarmaterials. Absolute minimum allowance for expansion of parts ex-posed to flame or exhaust gases (pistons, piston rings, and valves)is 0.001 inch for each 1 inch of diameter or length. In anticipating theexpansion of a piston to make allowances for the additional clear-ance required in the cylinder, 0.001 inch for each 1 inch of diameteris added. In anticipating the expansion of a piston ring, to makeallowances for the additional gap required between the ends of thepiston ring, 0.001 inch for each linear inch of the part is added.ยง 141. f.3695-4749Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
