Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Assembly of engine page 42
Fig. 48—Timing Markssurface with the sharp corners of the cams. Make sure the timingmark on the camshaft gear is in line with the timing mark on thecrankshaft gear (fig. 48).e. Install Push Rod and Valve Assemblies. Place a push rodin each push rod bore. If any of the push rods stick in the bore, theyare too tight and must be replaced. Place each valve assembly in itsrespective port, and install the valve guide bushing retainers (fig.49). Turn the camshaft until No. 1 push rod is resting on the heelof the cam (fig. 50). With a thickness gauge, check the clearancebetween the push rod and the end of the valve stem (fig. 51). If theFig. 49—Installing Valve Guide Bushing Retainer§ 131. C.3695-4742RM-518TIMING MARKSVALVE GUIDE BUSHING RETAINER—6512Valve Lifter—6505-ARM-656Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
