Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Oil pump page 31
3695-47§ 126. a.31Fig. 30—Removing Oil Pump Drive Gear From Driven Gear and Bodyor chipped teeth. Replace the driven gear if it is less than 0.560 inchlong, or if the teeth are worn, chipped, or broken. Replace a brokenor damaged oil pump screen cover assembly.Fig. 37—Oil Pump, DisassembledDRIVEN GEARDRIVE GEARASSEMBLYDriftRM-528BODY ASSEMBLY—6603DRIVE GEAR ASSEMBLY-6608RM-515DRIVE GEAR SHAFTDRIVEN GEAR—6610DRIVE GEAR BUSHING—6612DRIVEN GEAR—6614Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
