Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Water pump page 33
Fig. 33—Removing Water Pump Pulleyb. Cleaning. Clean all of the metal parts thoroughly withcleaning fluid.c. Inspection. Replace a cracked or damaged water pump body(fig. 34). Replace the water pump seal if it is worn. Replace animpeller if it is cracked, excessively pitted, or if it has broken ordamaged fins. Replace a pulley hub that is cracked or has strippedthreads. Rotate the water pump bearing. If the bearing binds or hasa tendency to stick, replace the bearing assembly. Replace thebearing assembly if there is end play or side play in the shaft.Fig. 34—Water Pump, Disassembled3695-47§ 127. c.33PullerWATER PUMP PULLEYWATER PUMPHOUSINGRM-595FAN PULLEY—8610BEARING—8530GASKET—8507SEAL-8564IMPELLER—8516COVER PLATE—8508RM-516HOUSING—8505BEARING SLINGER—8550BEARING RETAINER—8576Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
