Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Camshaft and valve mechanism page 29
RM-69Fig. 28—Checking Valve Spring Tension(b) VALVE GUIDES.NOTE: Any new valve guides that are to be used should beused as intake valve guides in order to keep the intake valveguide clearance to a minimum.Using a valve with a stem diameter of 0.311 inch as a gauge,place the valve in each half of the valve guide bushing, and measureeach side with a micrometer, as shown in fig. 29. Replace both halvesof any valve guide bushing if the measurement is less than 0.6665inch. Select guides for each valve, measuring each half with thevalve with which it is to be used. Any new guides being used andthe old guides having the least wear should be used with the intakevalves. Any guide and valve combination measuring more than0.666 inch is satisfactory for exhaust valves.3695-47§ 124. C. (1) (b)29Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
