Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 1 - Engine

Camshaft and valve mechanism page 28

Ford 8N, 9N, 2N Service Manual, page 28Fig. 27—Disassembling Valve Assemblyare scored or cracked. Pressed-steel type push rods may be resur-faced at the bottom end only. Replace any push rods that are lessthan 1.710 inches long after resurfacing.c. Valves, Guides, and Springs. Hold the valve assembly in thehand, and compress the valve spring as shown in fig. 27. Lift one-half of the valve guide bushing from the assembly. Remove theother half of the valve guide bushing, spring, and spring retainer(fig. 26).NOTE: Keep the two halves of each valve guide together inpairs.(1) CLEANING, INSPECTION, AND REPAIR. Scrape thecarbon off the valve heads and stems. Clean the valves, springs, andvalve guide bushings.WARNING: Do not use caustic or any material that will injurethe protective coating of paint on the valve springs. This paintis necessary to protect the spring from crankcase moisture.Replace valves that have bent or scored stems. Replace anyvalves the stems of which are worn to less than 0.3065 inch. Refacepitted, corroded, or burned valves. Replace valves that are pitted,burned, or warped that will not clean up with a light cut of thegrinding wheel. If a cutter was used to reface the valve seats in thecylinder block, lap each valve into its seat.(a)VALVE SPRINGS.Replace a valve spring if it has lost its pro-tective coating of paint, or if the tension is less than 30 pounds or ismore than 34 pounds when compressed to 2.13 inches (fig. 28).§ 124. C. (1) (a)3695-4728RM-71

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?