Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Pistons and connecting rods page 24
Fig. 20—Checking ConnectingRod for BendFig. 21—Checking ConnectingRod for Twist(4) CONNECTING ROD BEARINGS. Replace connecting rodbearings that are worn, pitted, scored, or discolored (due to over-heating). Bearings otherwise satisfactory but with small pits neednot be replaced. Bearings must be replaced where pits extend to theside of the bearing and permit oil to escape. Place a plug gauge(a round piece of accurately ground or rolled bar stock) on theinside surface of the bearing, and measure the thickness of the twopieces (fig. 22). Deduct the thickness of the bar stock from thereading obtained to determine the thickness of the connecting rodinsert bearing. Replace each connecting rod bearing that measures0.005 inch or more under its original size-.b. Fitting Oversize Piston Pins.NOTE: This procedure applies only when piston pins are to befitted to old pistons. When new pistons are used, the connect-ing rod bushings must be replaced if the old bushing does notprovide the correct fit for a standard piston pin (par. d below).If a connecting rod bushing or a piston pin hole is worn and itsinside diameter does not measure more than 0.7535 inch, it can bereamed and burnished or honed to fit a 0.001 inch or a 0.002 inchoversize piston pin. The correct fit for a piston pin in the connectingrod bushing exists when the pin to be used will pass slowly throughthe bushing by its own weight when the piston and pin are dry. The§ 123. b.3695-4724PISTON PINCONNECTINGRODPISTON PINCONNECTING RODConnecting Rod AlignerRM-338RM-400Connecting Rod AlignedFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
