Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Pistons and connecting rods page 25
correct fit for a piston pin in the piston exists when it can be insertedin the piston by a light push by hand with the piston and pintemperature at approximately 70 degrees.c. Connecting Rod Bushing Replacement. Drive the bushingfrom the connecting rod with a suitable driver. Press a new bushinginto the connecting rod. Drill the four oil holes in the bushing to thesame size as the holes in the connecting rod. Ream and burnish orhone the bushing to 0.7505 inch. Check the alignment of the con-necting rod, correcting any misalignment (figs. 20 and 21).3695-47§ 123. c.25Fig. 23—Measuring Piston Ring End GapCONNECTING RODBEARINGMICROMETERROUND PIECE OF STOCKRM-412Fig. 22—Measuring Connecting Rod Bearing for WearPISTON RINGFeeler GaugeRM-517Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
