Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Pistons and connecting rods page 23
Fig. 19—Checking Ring Groove Width(b)PISTON PIN BORES.Use a new piston pin as a gauge, andinsert it in the piston pin bore. If the pin falls through by its ownweight, the pin bore is excessively worn and must be reamed andburnished or honed to accommodate an oversize piston pin (par. bbelow).(c)PISTON RING GROOVES.Check the width of the ring grooveswith a new piston ring and a thickness gauge (fig. 19). Discard apiston if the clearance between the ring and the piston exceeds0.004 inch.(2) PISTON PINS. Replace piston pins that have become wornand measure to less than 0.749 inch.(3) CONNECTING RODS. Replace connecting rods which havedamaged studs. To check the piston pin bushing for wear, use a newpiston pin as a gauge. If any looseness is felt, rebush the connectingrod (par. c below), or fit an oversize piston pin in both the connectingrod and the piston (par. b below). Check the connecting rods forbeing twisted. Bent or twisted connecting rods must be aligned(figs. 20 and 21). Where possible, use the original connecting rod foreach cylinder. If any of the old rods are used in a different cylinder,file off the old number. Number each rod and cap as follows: Use1/2inch steel stamps for numbering the connecting rods and caps,placing the new number in the same position as the old one.3695-47 § 123. a. (3)23RM-514PISTON RINGThickness GaugePISTONFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
