Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Pistons and connecting rods page 22
Fig. 18—Fitting Piston to Cylinder Borea. Inspection.NOTE: Usually, the type of wear, or the condition of one ofthe reciprocating parts, can indicate a fault in other recipro-cating parts, i.e. a bent connecting rod could result in unusualwear, on either, or both, the piston or the connecting rodbearing.(1) PISTONS. Discard pistons which are cracked, scored, dam-aged or have burned spots.(a)FITTING PISTONS. TOcheck the clearance of a piston in acylinder bore, use a thickness gauge1/4-inch wide and long enough tocover the entire length of a piston, and attach it to a tension scale.Place the gauge on the side of the piston bore, and push the pistonin the cylinder so that the side of the piston, which is 90 degrees(right angle) from the piston pin hole, is against the thicknessgauge. Withdraw the gauge and observe the reading on the tensionscale (fig. 18). The thickness of the gauge to be used and the poundspull for the various combinations of pistons and cylinder bores areas follows:Steel PistonCylinder Bore andGauge PullPiston CombinationsThickness PoundsNew steel sleeve—new piston0.003 5-8Worn steel sleeve—new piston0.004 5-8Worn steel sleeve—worn piston0.005 5-8§ 123. a. (1) (a)3695-4722New steel sleeve—new piston0.003 5-8Worn steel sleeve—new piston0.004 5-8Worn steel sleeve—worn piston0.005 5-8§ 123. a. (1) (a)3695-47Steel PistonCylinder Bore andGauge PullPiston CombinationsThickness PoundsPiston Pull Scale—6110-ACYLINDER BLOCKPISTONRM-504Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
