Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Cylinder block page 19
Fig. 14—Removing CylinderSleevec. Stud Replacement. Remove all damaged studs with astandard stud puller (fig. 13). To remove a broken stud, indent theend of the broken stud exactly in the center with a center punch.With a small drill, drill into the broken stud to a depth of approxi-mately two-thirds of the length of the remaining portion of the stud,then follow up with a larger drill. The larger drill selected must leavea wall thicker than the depth of the threads. Select an extractor(EZ-out) of the proper size and insert it into the drilled hole, andscrew out the remaining part of the broken stud. Install a new studwith a stud driver. Drive all studs until no threads show at thebottom of the stud.d. Valve Seat Insert Replacement. Remove the valve seatinserts, being careful not to damage the cylinder block. If thecounterbore is worn, remachine it to obtain a 0.0015 inch to 0.003inch press fit on the replacement insert. Make sure that the counter-bore is clean. Pack the new insert in dry ice for at least 15 minutes,and drive the insert in place in the counterbore, using a driver thatassures the insert going into place evenly. Reface the valve seatinsert (par. e below).3695-47§ 122. d.19Sleeve Crushing ToolSLEEVERM-637Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
