Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Chapter 1 - Engine

Crankshaft and flywheel page 15

Ford 8N, 9N, 2N Service Manual, page 15RM-508Fig. 9—Installing Crankshaft Geareach journal diameter at a minimum of four places to determinesize, out-of-round, and taper. Remachine any journals that are out-of-round more than 0.0015 inch. Remachine journals that tapermore than 0.001 inch (subpar. (1) below). Journals that are wornevenly with less than 0.001-inch taper, or less than 0.0015-inchout-of-round, need not be reground if the available bearings willprovide not more than 0.003 inch clearance for the main bearings,or not more than 0.005 inch for the crankpin bearings.(1) REMACHINING CRANKSHAFTS. Subtract the amountof undersize of the bearings to be used from the original size, andremachine the crankshaft by grinding it to this new size, thenpolish with No. 320 grit polishing paper, removing not more than0.0009 inch from the diameter.(2) CRANKSHAFT GEAR REPLACEMENT. Remove thecrankshaft gear with a puller that pulls the gear evenly (fig. 8).Remove the woodruff key. To install the crankshaft gear, tapthe woodruff key into the crankshaft, and install the gear on thecrankshaft with a replacer as shown in fig. 9.b. Flywheel. Clean the flywheel (fig. 11) thoroughly. Replaceor reface a flywheel that has an excessively worn or scored frictionface. Replace a flywheel ring gear (subpar. (1) below) that is cracked,chipped, or has excessively worn teeth.3695-47§ 121. b.15Crankshaft Gear Replacer—6316-CCRANKSHAFT GEARCRANKSHAFT

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?