Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Engine disassembly page 13
i. Remove Crankshaft. Remove the lock wire and castellatednuts or self-locking nuts from the main bearing caps (fig. 7), andremove the bearing caps. Lift the crankshaft from the cylinder block.Fig. 7—Removing Connecting Rod and Piston Assembly3695-47§ 113. i.13CYLINDER BLOCKOIL PUMP SCREEN COVERCAMSHAFT CRANKSHAFT CONNECTING RODSOIL PUMP DRIVE GEARCYLINDER FRONT COVEROIL SEALOIL SLINGERCRANKSHAFT GEAROIL PUMP BODYRM-505CENTER MAIN BEARING CAPCONNECTINGRODSFig. 6—Underside of Engine with Oil Pan RemovedREAR MAINBEARING CAPOIL SEALFLYWHEELHammerCONNECTING RODCYLINDER BLOCKRM-506Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
