Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Governor page 36
Fig. 38—Driving Grooved Pinfrom Fork and LeverFig. 39—Removing GovernorDrive Gear(5) BALLS. Replace a ball that has flat spots, pits, or that isdamaged in any way. A discolored ball is due to a chemical reactionand does not effect the serviceability of a ball.(6) UPPER RACE. Replace the upper race (fig. 37) if it is groovedor pitted.(7) THRUST WASHER. Replace the thrust washer (fig. 37) ifany of the balls are missing, or if any of the balls have flat spots.(8) FORK BASE. Replace the fork base (fig. 36) if it is worn ordamaged.(9) BODY. Replace the body (fig. 36) if it is cracked or if thetrunnion for the manual lever measures less than 0.916 inch. Replacethe bushing (par. c below) (fig. 37) if there is more than 0.005 inchclearance between the shaft and bushing. Replace the needle bearingif any of the needles are flat, or if any are missing. Always replacethe grease seal if the shaft has been removed. Replace the fork if thebearing surface is worn flat.§ 128. a. (9)3695-4736RM-632RM-583Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
