Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Carburetor page 53
Figure 18—Carburetor, DisassembledRemove the two screws which secure the throttle plate to the shaft.Remove the plate and throttle shaft from the throttle body.c. Disassemble Carburetor Body. Remove the main meteringjet (fig. 19) with a screw driver or jet wrench. Remove the two screwsand lock washers that secure the choke plate in the choke lever andshaft. Pull the choke plate out of the shaft with a pair of pliers. Removethe choke shaft and lever and choke return spring from the carburetorbody.222. CLEANING, INSPECTION, AND REPAIR.Clean all part thoroughly in a cleaning solution. Blow out all jetswith compressed air.a. Carburetor Body. Replace the carburetor body if it is cracked,if the threads are stripped, or if the jets are plugged and cannot beopened without damaging the jets.§ 222. a.3675-48-C53THROTTLE LEVER AND SHAFT—9581THROTTLE ADJUSTMENT SCREW SPRING—9589THROTTLE ADJUSTMENT SCREW — 9610MAIN ADJUSTMENT NEEDLE—9565MAIN ADJUSTMENT NEEDLE SPRING—9540WASHER-356211-SMAIN ADJUSTMENT NEEDLE GASKET—9563FUEL INLET STRAINER—9553FLOAT LEVER SHAFT—9558CARBURETOR THROTTLE BODY—9506MAIN ADJUSTMENT RATCHET—9536SCREWS—355000-SFLOAT NEEDLE SEAT GASKET—9569FLOAT NEEDLE AND SEAT—9564UPPER TO LOWERBODY GASKET—9519FLOAT AND LEVER-9550MAIN AIR INTAKE DRAINCARBURETOR DRAIN PLUG—358043-SRM-461CARBURETOR BODY—9507VENTURI —9586ECONOMIZER JET—9914IDLER JET—9596IDLE ADJUSTMENT NEEDLE—9541NEEDLE SPRING—9578IDLE ADJUSTMENTTHROTTLEPLATE—9585Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
