Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Data8
- Accessory removal9
- Engine disassembly10
- Crankshaft and flywheel14
- Cylinder block16
- Pistons and connecting rods21
- Camshaft and valve mechanism26
- Cylinder head and front cover30
- Oil pump30
- Water pump32
- Governor34
- Oil pan, intake and exhaust manifolds38
- Assembly of engine40
- Installation of accessories46
- Definition of fits48
- Fits and tolerances50
- Torque wrench readings51
- Carburetor52
- Servicing the starter58
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
Chapter 1 - Engine
Oil pan, intake and exhaust manifolds page 39
Fig. 44—Correcting InsufficientClearance on GovernorArmFig. 45—Correcting ExcessiveClearance on GovernorArmTo clean the intake and exhaust manifolds, scrape off all the carbonand all parts of the old gaskets. Clean the manifolds thoroughly.Replace a manifold that is cracked or broken. Replace broken ordamaged manifold studs (sec. 122).3695-47§ 129.39Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
