Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Engine: new valves and adjustable tappets112
- Engine overhaul gasket kit 8N-6008112
- Replacing crankshaft bearing liners113
- Intake valve seat insert change114
- Wrenches for adjustable tappets115
- Head bolt torque specifications115
- 8N engine overhaul115
- Servicing cast iron sleeves 8N-6055-B116
- Engine valve clearance116
- Oversize pistons and ring sets116
- Ignition: installing and timing the angle drive distributor117
- Distributor shaft 8N-12175117
- Corrections to the operator's manuals118
- Dust shield kit for the angle drive distributor118
- Transmission jumping out of reverse119
- Hydraulic pump exhaust valve retaining pins119
- 74034-S pin in the hydraulic lift cover120
- Servicing the 8N-640-A2 hydraulic pump exhaust valve121
- Rear axle spline and hub121
- Front wheel toe-in locating marks122
- Generator 8N-10000-B on 2N and 9N tractors122
- Carburetors on 8N tractors123
- 8N tractor changes 1 to 11123
- Bulletin Attachments126
Chapter 8 - Service Bulletins
8N tractor changes 1 to 11 page 123
2. INSTALLATION PROCEDURE:Complete installation instructions and a wiring diagram are in Attachment #8.Please note that the new 8N-10000-B generator can only be used in conjunctionwith the new 8N-10505-C regulator.3. SECURING GENERATORS AND KITS:When ordering a complete conversion assembly, order Generator 8N-10000-B andKit No. 2N-10042 in the usual manner.FUELBulletin Subject: Carburetors on 8N Ford TractorsSince the introduction of the 8N Ford Tractor, several changes have been madein the carburetor to obtain greater fuel economy and better tractor performance.The information in Attachment #9 will aid in identifying the several variationsof the carburetor that have been used, and outlines a procedure to use in thefield service of this assembly.MISCELLANEOUS OR GENERALBulletin Subject: 8N Tractor ChangesConsistent with the efforts of the entire organization to continually improveour products, we are pleased to announce the following changes in the 8N Tractor,Change No. 1 on All Tractors Starting with Serial No. 217307 on September 1, 1949Old No. 8N-695-A2 Bushing (hydraulic pump intake valve) replaced byNew No. 8N-695-B Bushing (hydraulic pump intalce valve)The old bushing had four intake holes and a large chamfer, while the newbushing has but two intake holes; and instead of a chamfer there is just asmall radius to break the sharp edge. The new bushing does not allow a surgeof oil to reach the pistons and cause too rapid a rise in the implements.123Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
