Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Engine: new valves and adjustable tappets112
- Engine overhaul gasket kit 8N-6008112
- Replacing crankshaft bearing liners113
- Intake valve seat insert change114
- Wrenches for adjustable tappets115
- Head bolt torque specifications115
- 8N engine overhaul115
- Servicing cast iron sleeves 8N-6055-B116
- Engine valve clearance116
- Oversize pistons and ring sets116
- Ignition: installing and timing the angle drive distributor117
- Distributor shaft 8N-12175117
- Corrections to the operator's manuals118
- Dust shield kit for the angle drive distributor118
- Transmission jumping out of reverse119
- Hydraulic pump exhaust valve retaining pins119
- 74034-S pin in the hydraulic lift cover120
- Servicing the 8N-640-A2 hydraulic pump exhaust valve121
- Rear axle spline and hub121
- Front wheel toe-in locating marks122
- Generator 8N-10000-B on 2N and 9N tractors122
- Carburetors on 8N tractors123
- 8N tractor changes 1 to 11123
- Bulletin Attachments126
Chapter 8 - Service Bulletins
Hydraulic pump exhaust valve retaining pins page 119
Corrective measures are as follows:1. Replace the cam and weights assembly, Part No. 8N-12176, if found to bescored.2. Install new points with contact spacing of .024. - .026.3. Lubricate the cam in accordance with the instructions given in Section 364,Paragraph E, Page 93 of the Ford Tractor Operator's Manual.4. Clean the contacts with chloroform after they have been properly spaced.5. Install the Dust Shield Kit as outlined in the instructions contained ineach kit.TRANSMISSIONBulletin Subject: Transmission Jumping Out of Reverse and/or Locking inReverse and Another Gear at the Same Time.A few cases have been reported to us from the field regarding transmissionsjumping out of reverse or locking in two gears, (i.e. reverse and one of theforward gears) and excessive wear on the 8N-7100 Gear and Mating Shaft.We have found in these instances that the snap ring groove in the 8N-7141, Gearand Bushing Assembly, is not sharp and square or the snap ring itself, Part No.9N-7070 may have the edges on the inside diameter chamfered rather than square.To correct this condition, install a new 8N-7141 gear and bushing assembly or a9N-7070 Snap Ring whichever is required.NOTE: This applies to transmissions jumping out of reverse gear only, afterserial number 245636.Regular S.A.R. procedure is to be followed in all cases pertaining to the above.HYDRAULICBulletin Subject: 8N Tractor Hydraulic Pump Exhaust Valve Retaining Pins,8N-641-A and 8N-641-B1. PROBLEM.How to determine which pin to order for servicing tractors.2. TRACTORS AFFECTED:Retaining Pin No. 641-A was used in 8N tractors from Serial No.8N-1 thru 8N-56751.119Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
