Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Engine: new valves and adjustable tappets112
- Engine overhaul gasket kit 8N-6008112
- Replacing crankshaft bearing liners113
- Intake valve seat insert change114
- Wrenches for adjustable tappets115
- Head bolt torque specifications115
- 8N engine overhaul115
- Servicing cast iron sleeves 8N-6055-B116
- Engine valve clearance116
- Oversize pistons and ring sets116
- Ignition: installing and timing the angle drive distributor117
- Distributor shaft 8N-12175117
- Corrections to the operator's manuals118
- Dust shield kit for the angle drive distributor118
- Transmission jumping out of reverse119
- Hydraulic pump exhaust valve retaining pins119
- 74034-S pin in the hydraulic lift cover120
- Servicing the 8N-640-A2 hydraulic pump exhaust valve121
- Rear axle spline and hub121
- Front wheel toe-in locating marks122
- Generator 8N-10000-B on 2N and 9N tractors122
- Carburetors on 8N tractors123
- 8N tractor changes 1 to 11123
- Bulletin Attachments126
Chapter 8 - Service Bulletins
Distributor shaft 8N-12175 page 117
In Attachment #6, instructions outline the correct procedure for installing thefollowing oversize piston assemblies and ring sets.PISTON ASSEMBLIESRINGSETS8N-6108-D .020O.S.8N-6l49-D.020 O.S.8N-6108-E .030O.S.8N-6149-E.030 O.S.8N-6108-F.040O.S.8N-6149-F.0140O.S.Instructions should be followed in detail to obtain satisfactory results.IGNITIONBulletin Subject: Installing and Timing the Angle Drive Distributor on the8N TractorThis bulletin and attachment #7 constitute the complete instructions for in-stalling and timing the new angle drive distributor announced in ServiceBulletin No. ll4, dated March 30, 1950. Replacement parts for the new angledrive distributor are covered in Service Parts Release and Change Notice 50—4.This distributor can be installed and timed without instrumentation, but westrongly advise the use of a stroboscopic timing light. In the interest ofquality service and in order to assure maximum tractor performance, we re-commend that every one of your dealers, not so equipped, purchase one of thesetiming lights. Such a light will improve the efficiency of the dealer'sservice department by assuring accurate timing — the first time. This willreduce your dealer's service expense by speeding up the initial operation andeliminating the need for repeat service calls.Bulletin Subject: Distributor Shaft 8N-12175 as Supplied in Parts StockThe subject shafts are supplied as service parts without the holes drilled inthem to pin the collar and gear to the shaft. In production, these holes aredrilled after the shaft has been installed in the distributor assembly, so asto obtain the proper end play of the shaft.In order to obtain this same clearance with the use of service parts, thefollowing procedure is to be followed in the field.1. Install the shaft in the distributor housing.2. Put a .002 to .005 shim or feeler at the bottom end of the housingbefore slipping the collar on. This will provide for the properamount of end play.117Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
