Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Engine: new valves and adjustable tappets112
- Engine overhaul gasket kit 8N-6008112
- Replacing crankshaft bearing liners113
- Intake valve seat insert change114
- Wrenches for adjustable tappets115
- Head bolt torque specifications115
- 8N engine overhaul115
- Servicing cast iron sleeves 8N-6055-B116
- Engine valve clearance116
- Oversize pistons and ring sets116
- Ignition: installing and timing the angle drive distributor117
- Distributor shaft 8N-12175117
- Corrections to the operator's manuals118
- Dust shield kit for the angle drive distributor118
- Transmission jumping out of reverse119
- Hydraulic pump exhaust valve retaining pins119
- 74034-S pin in the hydraulic lift cover120
- Servicing the 8N-640-A2 hydraulic pump exhaust valve121
- Rear axle spline and hub121
- Front wheel toe-in locating marks122
- Generator 8N-10000-B on 2N and 9N tractors122
- Carburetors on 8N tractors123
- 8N tractor changes 1 to 11123
- Bulletin Attachments126
Chapter 8 - Service Bulletins
Generator 8N-10000-B on 2N and 9N tractors page 122
are now being stamped with a punch mark which will enable you to alwaysrealign them in the same position.3. FIELD CORRECTION:In performing rear axle service operations on tractors built prior to theabove serial number, we advocate the following field procedure. Beforedisassembling the rear axle and hub, punch a similar mark on both the huband rear axle, so that in the reassembly operation you will be able tomatch the hub to the rear axle as it was before disassembly.STEERINGBulletin Subject: Locating Marks for Adjustment of Front Wheel Toe-inon the 8N Tractor1. PROBLEM:Difficulty in centering the steering arm over the front axle locating mark.2. PRODUCTION CORRECTION:Beginning with tractor serial number 8N-181515, toe-in marks on the frontaxle were moved from the axle half to a point on the spindle housingdirectly below the slot in the steering arm, when the wheels are straightforward.3. FIELD CORRECTION:Until such time as there is a reprint for the Ford Tractor Operator'sManual (3729-49-C), it will be necessary for dealers to inform customersof the new location of these toe-in marks. The procedure for adjustingthe turnbuckle on the drag links remains the same. However, be sure toalign the slot in the steering arm with the toe-in mark on the spindlehousing.ELECTRICALBulletin Subject: Installation of Generator 8N-10000-B on 2N and 9N Tractors1. NEW PARTS REQUIRED:A. 8N-10000-B GeneratorB. 2N-100422 Kit (This kit contains all parts necessary to complete subjectinstallation).122Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
