Free shipping to US addressesShips the next business day Call 260-496-8606
NewOldManuals.com Service, parts & operator's manuals for tractors and construction equipment
Cart (0)
Storewide sale — 20% off every manual · plus free USA shipping
Chapters

All chapters and sections

  1. Contents1
  2. Description and Specifications3
  3. Chapter 1 - Engine8
  4. Chapter 2 - Transmission61
  5. Chapter 3 - Power Take-Off71
  6. Chapter 4 - Belt Pulley75
  7. Chapter 5 - Rear Axle79
  8. Chapter 6 - Hydraulic System89
  9. Chapter 7 - Steering Gear101
  10. Chapter 8 - Service Bulletins111
  11. Bulletin Attachments126

Bulletin Attachments

#9 Identifying and servicing carburetors page 142

Ford 8N, 9N, 2N Service Manual, page 142ATTACHMENT //9Page 1 of 2IDENTIFICATION AND SERVICING OF CARBURETORS ON 8N FORD TRACTORSA. Starting with Tractor Serial No. 8N-313112, a modified 8N carburetor becamestandard in production.B. The following cross reference between the part numbers assigned and the partnumbers used by the Marvel-Schebler Corporation will provide identificationof all carburetors used on the 8N Ford Tractor.Part No.Marvel-Schebler Part No.Type Carburetor9N-9510TSX 339N carburetor used on tractors priorto Serial No. 2605968N-9510TSX2418N carburetor used on tractors betweenSerial Nos. 260596 and 276115 (withouteconomizer jet).8N-9510TSX 241A 8N carburetor used on tractors betweenSerial Nos. 276115 and 313112 (witheconomizer jet)8N-9510TSX 241B 8N carburetor used starting with SerialNo. 313112 (modified)NOTE: The Marvel-Schebler part number will be found on the boss located onthe right hand side of the carburetor body.C. The steps listed below are provided for guidance as an aid in the correction ofcomplaints of unsatisfactory performance that may be encountered.1. Check the timing of the distributor as outlined in Service Bulletin 115.2. Disassemble the carburetor and clean it thoroughly.3. The operation of tractors equipped with the TSX-241 carburetor in whichthe engine tends to "stumble" either while idling or when placed underload, can be improved by installing the economizer jet, Part No. 8N-9914.The installation of this jet along with proper carburetor adjustment, willin most cases correct this "stumbling" condition. (See Service Bulletin 118)4. When reassembling the carburetor and fastening the halves together, careshould be taken in tightening the screws. The rear screws (next to theair inlet) should be securely tightened first.5. Both the 8N and the 9N carburetor are adjusted in much the same manner.In some cases, it may be necessary to open the idler adjustment needleof the 8N carburetor as much as one and one-quarter curns, and the mainadjustment needle one and one-half turns to obtain proper engine perfor-mance.142

Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?