Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#4 8N engine ring overhaul, general specifications page 131
ATTACHMENT #4FORD TRACTOR 8N ENGINE RING OVERHAULwithGeneral SpecificationsTo check the clearance of a piston in cyl-inder bore, use a thickness gauge 1/2" wideand long enough to extend over the entirelength of a piston. Attach the thickness gaugeto a tension scale and place gauge on the sideof the piston so that it is 90° (right angle)from the piston pin hole. Invert the piston,and without rings push into bore far enoughso as to have 1" to 1-1/2" clearance betweenbottom of piston and top of block, withdrawthe gauge and observe the reading on the ten-sion scale.The thickness gauge to use and thepounds pull for various piston and sleevecombinations are as follows:Cylinder and AluminumPiston CombinationNew Sleeve-New PistonNew Sleeve-Worn PistonWorn Sleeve-New PistonWorn Sleeve-Worn PistonPoundsThickness Gauge Pull.002 x 1/2 in. 5-10.003 x 1/2 in. 5-10.003 x 1/2 in. 5-10.004 x 1/2 in. 5-10RING GROOVE WIDTHCheck the width of the ring grooveswith new piston rings and a thickness gaugeevery 120° around the circumference ofpiston in accordance with the followingspecifications:Top Compression RingsSecond Compression RingsOil Control RingFITTING PISTON TO CYLINDER BOREDECKING RING GROOVE WIDTHPage 1 of 3131PISTONPISTON PULL. SCALECYLINDER BLOCKTHICKNESS GAUGEPISTONPISTON RINGSideWearClearance Limit.004.0035.004.0015-.003.001-. 0025.0015-.003Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
