Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#9 Identifying and servicing carburetors page 143
ATTACHMENT #9Page 2 of 2In adjusting the 9N carburetor, turn the idle adjustment needle approx-imately three-quarters of a turn open and the main adjustment needleone full turn open,NOTE: The fact that the 8N carburetor adjustment needles are openedmore than those on the 9N carburetor does not necessarily mean increasedfuel consumption. The increased openings in the 8N carburetor are dueto the difference in construction and venting of the bowl. The gas-oline consumption of the two carburetors should be approximately the same.6. In cases where a tractor with an 8N carburetor does not operate satis-factorily, even after the carburetor jets have been installed and thecarburetor properly adjusted, it is recommended that the entire carbure-tor assembly be replaced.In these cases submit an S.A.R. claim covering the cost of such replace-ment.The percentage of defective carburetors will be very low and the recommendationgiven in item 6 above is not to be construed as a basis for making an all out car-buretor replacement campaign.Correction should be made on Page 82 of the Ford Tractor Operator's Manual(Ford form 3729-50-F). The paragraph in the middle of the page reads:HThe idle adjustment needle should be opened approximately two and one-half revolutions."This sentence should be corrected to read:••The idle adjustment needle should be opened approximately one (1) revolu-tion."143Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
