Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#8 Installing the 8N-10000-B generator page 141
INSTALLATION DIAGRAMFOR INSTALLING 8N-10000B GENERATORON 2N and 9N TRACTORSAdditional Parts Required (not shownon diagram)1-2N-10181-B Generator belt adjustingclamp.1-2N-10599 Bracket-mounting regulator.3-33795-S7-8 hex nut1/4-20 mountingregulator to bracket.3-34805-S7-8 L/washer1/4" - mountingregulator to bracket.2-34079-S8 hex nut #10-32-Generatorfield and ground terminal.2-34803-S8 lockwasher #10 - generatorfield and ground terminalsl-34825-58 hex nut1/4-28 - generatorarmature terminal.1-3U825-S8 lockwasher1/4- generatorarmature terminal.9N-l4401-C Not Part of ThisAssembly, (original wire)(wasOriginal battery wireconnected to cutout)Generator field to voltage regulatorBlack with white tracerGenerator ground to voltage regulatorBlack with red tracerGenerator armature to voltage regulatorYellow with black tracerTape or cut both endsof original(yellow)cutout to generatorarmature wire8N-10505-BRegulatorGnd.BatteryStarter RelayFieldArm.Clip 91A-108824 Req.2N-14305 Wiring Assy.Generator to VoltageRegulatorArmGnd.Field2N 10000 BGeneratorFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
