Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#2 Adjustable tappet instructions page 129
INSTRUCTIONSATTACHMENT #2129To adjust a tappet, proceed as follows:1. Insert the protruding lip of thewrench into the rear hole of thetappet being adjusted.2. Place the other end under the headof the adjacent tappet as shown.3. To prevent interference with thetappet retaining wrench, grindthe head of your tappet adjustingwrench to the dimension shown.PROTRUDING LIPRIGHT HAND SHOWNREAR HOLEOF TAPPET8N-17045-ARIGHT HAND8N-17046-ALEFT HANDGRIND7/16-5"7/8" MAXFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
