Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#3 Head bolt torque and tightening sequence page 130
HEAD BOLT TORQUE SPECIFICATIONSCylinder Head Nuts50 to 55 Ft. Lbs.Cylinder Head Cap Screws ....65 to 70 Ft. Lbs.RECOMMENDED SEQUENCE FOR TIGHTENINGHEAD CAP SCREWS OR NUTSFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
