Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#6 Oversize piston and ring sets page 135
ATTACHMENT #6Installation InstructionsforOversize Piston and Ring Sets1. The following procedure is necessar7 prior to reboring and honing the cast ironsleeve, part no. 8N-6055-B, to fit oversize piston and ring assemblies.a. Determine which oversize piston assembly is required by measuring the dia-meter of the cylinder bore at its largest diameter (top of ring travel) byusing an inside micrometer or telescope gauge and outside micrometer.2. Install a cylinder boring machine on the cylinder block.a. Cover the crankshaft with an oil soaked cloth.b. Set the diameter of the cutting tool so that the cylinder bore will be .002"undersize to allow for honing the bore for the specified piston fit.c. The following are part numbers and mean diameters for service piston as-semblies.PISTON ASSEMBLIES8N-6110-D3.2080 Dia..020 O.S.8N-6110-E3.2180 Dia..030 O.S.8N-6110-F3.2280 Dia..040O.S.3. To obtain the required piston fit to cylinder bore of 5 - 10 pounds pull using a.002 x .50 ribbon and the specified sleeve finish for proper ring seating, thefollowing procedure is recommended.a. Use a rigid type hone and No. 220 grit stones. A drill with a speed rangeof 250 - 450 R.P.M. should be used to drive the hone. The stones must bedry when used to obtain the desired cylinder sleeve finish.NOTE: The speed of the hone and rapidity of the stroke governs the cross hatch markson the sleeve. The cross hatch marks should intersect at approximately 90° forproper ring seating.b. Operate the hone through the bore 10 or 12 complete strokes. Remove the hone,clean the sleeve with dry rags, and recheck the piston fit.135Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
