Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#7 Installing and timing the angle drive distributor page 137
CORRECT INSTALLATION AND TIMING PROCEDURE FOR THEANGLE DRIVE DISTRIBUTOR ON THE 8N FORD TRACTORATTACHMENT #7Page 1 of 3Remove #1 spark plug.With ignition off, placethumb or finger over the#1 spark plug hole andcrank slowly until com-pression is felt (Fig. 1).(Fig. 1)3. Continue to crank the engine untilthe timing mark, "0°" (dead center)on the flywheel, exactly aligns withthe pointer in the timing window(1) Fig. 1 on the right side offlywheel housing.NOTE: Flywheel is calibrated from "0°"to "20O"in two places, 180° apart.4. Insert the distributor assembly(1) Fig. 2. With the gears fullymeshed, the rotor should point tothe right front cylinder head bolt.If not, remove and re-engage untilthe proper rotor position is obtained(2) Fig. 3.NOTE: The breaker point gap on thisdistributor should be .025".(Fig. 2)137Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
