Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#7 Installing and timing the angle drive distributor page 138
ATTACHMENT #7Page 2 of 3Loosen the clamp screw (3), Fig. 3center the adjustment slot on thecap screw (4), Fig. 3 and tightenthe cap screw.Position the distributor housingso that the primary terminal ispointing to the rear (1), Fig. 3.Rotate the distributor "counterclockwise" until the breakerPoints are closed.(Fig. 3)Install the distributor cap;connect the primary, second-ary and #1 spark plug wires(See Fig. 4).Hold the end of #1 spark pluwire approximately 1/8" fromthe cylinder head or manifolwith the ignition "on", andthen slowly rotate the dis-tributor housing "clockwise"until a spark occurs at (1),Fig. 4. Tighten the clampscrew (3), Fig. 3 securely.The spark should occur inless than 1/8 turn of thedistributor housing.(Fig. 4)138Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
