Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#6 Oversize piston and ring sets page 136
ATTACHMENT #6Page 2 of 2c. Repeat the above procedure, until the necessary amount of material has beenremoved for the specified piston to bore fit.CAUTION: Do not use gasoline or kerosene to clean the sleeve walls after the honingoperation. Solvents of this type will not remove the abrasives but will further em-bed small abrasive particles into the pores of the cylinder block.NOTE* If valve seats need refacing, this should be done previous to cleaning thecylinder block.5. Clean the cylinder block of all foreign material as follows:a. Wipe or remove as much of the abrasive material as possible.b. Swab each sleeve wall, valve port and chamber with clean SAE 10 motor oilat least twice.c. Wipe the oil out of sleeves with clean rags.d. Wash the sleeve bores and valve chambers with hot soapy water.e. Flush water jackets to remove foreign material which might cause excessivewear to the water pump.f. Remove the rags from the crankshaft and wash the crankshaft with hot soapywater.g. Dry the cylinder block thoroughly, using compressed air.6. Reassemble the engine with reference to Service Bulletin Number 182, datedOctober 5, 1951.136Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
