Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#7 Installing and timing the angle drive distributor page 139
ATTACHMENT #7Page 3 of 3Install #1 spark plug andconnect all spark plugwires to_ their respectivenumbers on the distributorcap (1 to 1, 2 to 2,3 to 3, & 4 to 4).(Fig. 5)11.Check the timing and auto-matic spark advance withtiming light as shown in Fig. 5a. Connect the single timinglight wire to #1 sparkplug terminal (2), Fig. £and the double wire to thebattery (1), Fig. 5 andFig. 6.b. Start the engine and checkthe timing and automaticspark advance. The fly-wheel marks should line upwith the timing windowpointer, at various speeds,as follows:400-500 rpm 4°1000 rpm8°- 9°1500 rpm12°- 13°2000 rpm17°- 18°139(Fig. 6)Free to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
