Chapters
- Contents1
- Description and Specifications3
- Chapter 1 - Engine8
- Chapter 2 - Transmission61
- Chapter 3 - Power Take-Off71
- Chapter 4 - Belt Pulley75
- Chapter 5 - Rear Axle79
- Chapter 6 - Hydraulic System89
- Chapter 7 - Steering Gear101
- Chapter 8 - Service Bulletins111
- Bulletin Attachments126
- #1 Installing the new valve127
- #2 Adjustable tappet instructions129
- #3 Head bolt torque and tightening sequence130
- #4 8N engine ring overhaul, general specifications131
- #5 Servicing cast iron sleeves134
- #6 Oversize piston and ring sets135
- #7 Installing and timing the angle drive distributor137
- #8 Installing the 8N-10000-B generator140
- #9 Identifying and servicing carburetors142
Bulletin Attachments
#4 8N engine ring overhaul, general specifications page 133
ATTACHMENT #4Plastigage inserted onbearing shell before ithas been re-installedand tightened.Plastigage after bearingcap has been removed.This bearing has .0015"clearance.FITTING MAIN & CONNECTING ROD BEARINGSPlace a piece of Plastigage on the full width of the bearing insert. Installbearing cap and tighten nuts evenly with a torque wrench to 35 - 40 ft. pounds.Allow caps to remain tightened approximately one minute before removing caps tocheck Plastigage for oil clearance. Remove bearing. Flattened Plastigage willbe found adhering to either bearing shell or crankshaft. Determine bearing clear-ance by comparing width of flattened plastic at widest point with graduation oncontainer. If the clearance exceeds .003" on the main bearings, they should bereplaced. Replace the connecting rod bearings if the clearance exceeds .003".CONNECTING ROD AND PISTON ASSEMBLYPage 3 of 3133PLASTIGAGEFIT LOCATIONORIGINAL FIT FIT WEAR TYPE OFNAMETOLERANCES LIMIT FITConnecting rod sideclearancePiston pin clearance inconnecting rodPiston pin clearancein pistonPiston and cylinderTop piston ring togroove side clearanceSecond ringOil ringTop ring gapSecond ring gapOil ring gap.004 in. to.011 in..0001 in. to.0005 in. loose.000 in. to.0002 in. loose5-10 pounds pullon .002 x1/2in.shim.0015 in. to.0030 in..001.0025.0015.003.007.017 in..010-.017.010-.017.013 in..0012 in..0012 in.5-10 poundson .003 x/1/2in. shim.004 in..0035 in..004 in..030 in.Slip(LightPush)CRANKSHAFTFIT LOCATIONORIGINAL FIT FIT WEAR TYPE OFNAMETOLERANCES LIMIT FITCrankshaft end playMain bearing clearanceConnecting rod bearingclearance.002 in. to.006 in..0005 in. to.0025.0009 in. to.0025 in..008 in..005 in..005 in.RunningRunningandFloatingFree to read online. Contents · Where is the serial number on a 9N, 2N or 8N?
